Engineered Products
 Engineered Check Valves | Cushioned Swing Check Tilting Disc Check Controlled Closing Swing Check | | Pump Control Valves | CHECKtronic Pump Control Valves AWWA Ball Valves Electric Check Valves | | Surge Protection Valves | Surge Relief Valves Surge Anticipating Valves |
|
| AWWA Ball Valves |
Figure R507 Metal-Seated Ball Valve for Pump Control
|
|
|
- Fully conforms to American Water Works Association (AWWA) Standard C507
- Virtually zero headloss for lowest possible pumping cost
- Complete a GA Industries SURGE ANALYSIS CHECKLIST to have factory engineers review your pumping data and determine if the system would benefit from the zero headloss and surge control provided by a GA Industries pump control ball valve.
- Suitable for potable water, raw water, wastewater or raw sewage
- Sizes 6" to 48" (DN150 to DN1200)
- Pressure Class 150, 250 or 300 (ISO flanges and/or higher working pressures available)
- Water, air or oil cylinder actuated
- Standard with normal solenoid with independently adjustable opening and
- closing speed controls, emergency solenoid with separate emergency closing speed control and (3) limit switches.
- Optional Pump Director provides electrical logic to sequence operation of Figure
R507 with that of the pump motor
Standard Valve O & M
Standard Valve Data Sheets
Standard Valve Drawings
Build Specification
|
| |
Figure R201 Resilient-Seated Ball Valve for Pump Control
|
|
- Fully conforms to American Water Works Association (AWWA) Standard C507
- Virtually zero headloss for lowest possible pumping cost
- Complete a GA Industries SURGE ANALYSIS CHECKLIST to have factory engineers review your pumping data and determine if the system would benefit from the zero headloss and surge control provided by a GA Industries pump control ball valve.
- Suitable for potable water, raw water, wastewater or raw sewage
- Sizes 6" to 36" (DN150 to DN900)
- Pressure Class 150, 250 or 300 (ISO flanges and/or higher working pressures
available)
- Water, air or oil cylinder actuated
- Resilient UHMWPE ball seat field-replaceable through side access port using
common hand tools without need to remove valve or any associated piping
- Standard with normal solenoid with independently adjustable opening and closing
speed controls, emergency solenoid with separate emergency closing speed
control and (3) limit switches.
- Optional Pump Director provides electrical logic to sequence operation of Figure R201
with that of the pump motor
Standard Valve O & M
Standard Valve Data Sheets
Standard Valve Drawings
Build Specification
|
|
Model 7600 Pump Director Control Panel
|
|
GA Industries Figure R201 and R507 AWWA Ball Valves for pump control can be supplied with the optional Model 7600 Pump Director™ pre-wired control panel to simplify installation and properly sequence the operation of the pump motor and the ball valve.
|
|
|
